Goobay Satellite Window Feedthrough 26 cm – Ultra-Thin with Protective Rubber Sleeve
Would you like to route the satellite cable from your dish into your home without drilling through a wall or window frame? The Goobay satellite window feedthrough allows you to pass your coaxial cable through a suitable window or door.
The feedthrough has an overall length of 26 cm. Its 17 cm cable section is only 0.3 mm thick and 12 mm wide. Two F female sockets allow you to connect standard satellite coaxial cables fitted with F male connectors. The included rubber sleeve helps protect the designated F connection against water ingress.
The connector sections can be secured using either the included adhesive pads or mounting screws.
Key Benefits
- No drilling required: Route your satellite cable through a suitable window or door without drilling into the wall or frame.
- Ultra-thin design: Flat feedthrough section measuring only 0.3 mm in thickness and 12 mm in width.
- 26 cm overall length: Including a 17 cm cable section.
- Protected F connection: One included rubber sleeve helps protect the designated connection against water ingress.
- 2 F female sockets: Connect two coaxial cables fitted with F male connectors.
- Two mounting options: Adhesive pads and mounting screws are included.
- Discreet design: Transparent flexible circuit film.
Technical Specifications
- Brand: Goobay
- Product type: Satellite window feedthrough / flat coaxial cable
- Overall length: 26 cm
- Cable section length: 17 cm
- Thickness of flat feedthrough section: 0.3 mm
- Width of flat feedthrough section: 12 mm
- Connections: 2 × F female sockets
- Inner conductor: Copper (Cu)
- Characteristic impedance: 75 ohms
- Material / Design: Transparent flexible circuit film
- Mounting options: Adhesive pads or mounting screws
- F connection protection: 1 rubber sleeve
Easy Installation
- Open the window or door and select a suitable position on the frame.
- Carefully position the flat cable section across the frame. Keep the connector sections clear of the closing area.
- Slowly close the window or door and check that it closes without excessive pressure on the cable.
- If required, secure the connector sections using the included adhesive pads or mounting screws. Only use screws on a suitable mounting surface.
- Connect the two F female sockets to your satellite cables using suitable F male connectors.
- Fit the included rubber sleeve over the designated F connection to help protect it against water ingress.
Important Installation Notes
- The feedthrough is intended for suitable window and door frames. Check that sufficient clearance is available before installation.
- Avoid sharp bends, excessive compression and pulling forces.
- Frequent opening and closing may cause mechanical wear. Inspect the feedthrough regularly for damage.
- The rubber sleeve protects the designated F connection. It does not replace proper sealing of the window or door frame.
- When using the adhesive pads, make sure the mounting surface is clean, dry and suitable for adhesive mounting.
- Before using the screws, check that the mounting surface is suitable. Do not damage window or door seals.
Frequently Asked Questions (FAQ)
How can I run a satellite cable through a window without drilling?
Use an ultra-thin satellite window feedthrough. Its 0.3 mm flat cable section passes through a suitable window frame. The two F female sockets connect the feedthrough to your satellite cables inside and outside the building.
Can I close the window after installing the satellite feedthrough?
Yes, provided the window frame offers sufficient clearance for the flat cable section. Compatibility depends on the window design. Close the window carefully and avoid excessive compression of the cable.
Is the satellite window feedthrough waterproof?
One rubber sleeve is included to help protect the designated F connection against water ingress. Make sure the sleeve is correctly fitted during installation. It does not seal the window or door frame.
How can I secure the window feedthrough?
The connector sections can be secured using the included adhesive pads or the included mounting screws. Choose the mounting method that suits the surface.
Which connectors does the window feedthrough have?
The feedthrough has one F female socket at each end. You need coaxial cables fitted with suitable F male connectors.
How long is the satellite window feedthrough?
The overall length is 26 cm. The cable section is 17 cm long. The flat feedthrough section measures 0.3 mm in thickness and 12 mm in width.
Can I also use the feedthrough with a door?
Yes, provided the door frame offers sufficient clearance and the cable is not excessively compressed when the door closes. Avoid areas exposed to high mechanical stress.
Package Contents
- 1 × Goobay satellite window feedthrough, 26 cm
- Adhesive pads for mounting
- Mounting screws
- 1 × Protective rubber sleeve for the F connection
Additional satellite connection cables are not included.
Manufacturer Information / EU Responsible Person
Wentronic GmbH
Pillmannstraße 12
38112 Braunschweig
Germany
Email: office@wentronic.com
WEEE Registration No.: DE 82898622
Deutsch
Türkçe
English